Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Last Updated: 25.06.2025 02:34

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

At one ohm, the resistor has a maximum of 1 watt power.

This one hit behind the barn.

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

How do you protect the collagen in your face?

A circuit breaker is similar, but is resettable.

These devices are installed between the “hot” and “neutral” and protective ground.

First Sentence:

What are LGBT+ people tired of hearing?

A fuse is a non-resetable over current circuit protector.

[image of Common-mode choke]

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

Most people aren’t following this important dietary advice. Are you? - The Washington Post

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

An AC voltage/ current source, and an ac inductive load.

The other is “what does a “fuse” do?”

Repellat quod recusandae rerum adipisci deleniti.

This device then solves the entire problem.

[old diagram got deleted by accident]

so, what happens?

How do you make a karaoke version of a song?

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

One is “what exactly is in a ‘surge protector’ ? ”

In schematic diagrams this is the symbol for a fuse:

If a female has XX chromosomes and a male has XY chromosomes, what chromosomes do transgenders have?

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

Barnstars:

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

Amazon Draws Whole Foods Closer in Grocery Unit Reorganization - Bloomberg

One

nine

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

Elden Ring Nightreign Is Getting An Official Hardcover Strategy Guide - GameSpot

But it can get overloaded, and no longer works.

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

(Dc diagram shown, AC is similar).

Do you prefer wired headphones or wireless earbuds?

2024–10–16 [ OO OLAOYE OYEBODE ]

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

Why are terrible, boring art pieces done by famous people worth so much while beautiful pieces done by amateurs are worthless?

but this device (an Inductor) … impedes the rapid changes in the current.

This is the picture of an electronic coil of wire wound around a core of magnetic material.

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

With long courtship behind him, Aaron Rodgers learning the Steelers ropes on 'first day of school' - Pittsburgh Post-Gazette

Upvotes:

These are simplified answers to the original question, and does not change anything I wrote above.

Now when you have a certain ac resistance, then a current flows in a loop.

Bruce Willis’ Family Share Heartbreaking Health Update on ‘Die Hard’ Star - TV Insider

Because the load is inductive, the current lags the voltage.(by a bit).

This is 'the assistant's answer'

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

Elena and the Season 3 balance patch for Street Fighter 6 are technically releasing a day early due to time zone differences - EventHubs

The MOV will conduct when the voltage exceeds 50% of line voltage.

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

Why are there so many illegal Haitians in Ohio? They can't walk here. Democrats flew them here to cause chaos and crime in Ohio.

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

the problem then depends on "how fast does the fuse operate?".

Edit 2024–10.

‘Love Island USA’ Season 7 Contestant Yulissa Escobar Exits Show Amid Surfacing of Racist Clips - The Hollywood Reporter

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

Here is a simplified AC power diagram.

At least they know the answer if they wanted it.

eight

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

He then asserts :

but I think this circuit , shows a few more pieces.

I post the exact comment here.

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

a photo is worth a thousand words.

So, the voltage could go up to 500 volts, and the fuse will not open up.

There are two important concepts here.

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

He then describes Rainy Season and Lightning.

what exactly is a ‘surge’ protector?

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

This is where this question deviates from being a 'generic' question, and becomes more specific.

2024–10–14 [Omar Gharbi Omar Gharbi ]

This is where the MOV conducts again, and dissipated the energy.

He then describes the function of a fuse.

But… the neutral is now “floating” because of the 1 ohm resistance.

It also is a device that limits the change in current flow.

2024–10–10[John johnson John Johnson ]

It seems Mohan does not understand the difference between a comment and an Answer.

The third is lightning and “how it gets conducted into a home.”

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

The bolt then partially travels down the line to your home.

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

Can the fuse protect the electronic devices from lightning instead of a surge protector.

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

What does a fuse do?

What is lightning?

For this case there are devices called Metal oxide varistors (MOV).

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

There are three different concepts here that are getting confused.